CentOS Linux解决网卡启动时候报Device eth0 does not seem to be present错误

pasckr

                 　　在VMware里克隆出来的CentOS Linux。。
　　ifconfig...没有看到eth0.。然后重启网卡又报下面错误。
　　故障现象：
　　service network restart
　　Shutting down loopback insterface: [ OK ]
　　Bringing up loopback insterface: [ OK ]
　　Bringing up interface eth0: Device eth0 does not seem to be  present,delaying initialization. [FAILED]
　　解决办法：
　　首先，打开/etc/udev/rules.d/70-persistent-net.rules内容如下面例子所示：
　　# vi /etc/udev/rules.d/70-persistent-net.rules
　　# This file was automatically generated by the  /lib/udev/write_net_rules
　　# program, run by the persistent-net-generator.rules rules file.
　　#
　　# You can modify it, as long as you keep each rule on a single
　　# line, and change only the value of the NAME= key.
　　# PCI device 0x1022:0x2000 (pcnet32)
　　SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*",  ATTR{address}=="00:0c:29:8f:89:9
　　7", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"
　　# PCI device 0x1022:0x2000 (pcnet32)
　　SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*",  ATTR{address}=="00:0c:29:50:bd:1
　　7", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"
　　记录下，eth1网卡的mac地址00:0c:29:50:bd:17
　　接下来，打开/etc/sysconfig/network-scripts/ifcfg-eth0
　　# vi /etc/sysconfig/network-scripts/ifcfg-eth0
　　将 DEVICE="eth0" 改成 DEVICE="eth1" ,
　　将 HWADDR="00:0c:29:8f:89:97" 改成上面的mac地址 HWADDR="00:0c:29:50:bd:17"
　　最后，重启网络
　　# service network restart
　　或者
　　# /etc/init.d/network restart
　　正常了。
        注：更多精彩教程请关注三联电脑教程栏目，三联电脑办公群:189034526欢迎你的加入